Overcurrent relay has the in matlab.
Over current relay circuit diagram.
It is not present in simulink library so follow the steps given below.
Working principle of over current relay.
Over current relays are divided into two according to the structures.
In an over current relay or o c relay the actuating quantity is only current there is only one current operated element in the relay no voltage coil etc.
It protects the equipment of the power system from the fault current.
Fuses circuit breakers overcurrent relays current limiters temperature sensors and solid state power switches are used against overcurrent protection devices.
Take the subsystem block from commonly used blocks.
Since the normally closed contact is empty the led is off when there is no.
Earthing of both will short circuit the e l relay and make it inoperative for faults.
At least one relay will operate for fault involving two phase.
Are required to construct this protective relay.
The overcurrent relay is defined as the relay which operates only when the value of the current is greater than the relay setting time.
2 no o c relay 1 no e f relay for over current and earth fault protection.
Thermal overcurrent relay magnetic overcurrent relay.
In addition a thermal magnetic circuit breaker is used for both overcurrent and overload protection.
Double click the block.
A new window will open.
Circuit diagram of instantaneous overcurrent relay in simulink.
Depending on the time of operation the overcurrent relay is categorized into following types.
With the circuit shown in figure 1 7 led1 can be switched off by relay and button control.